The default height for everything is 10cm. (I've been asking for years
for a third click to determine height like every other 3d program in the
world). Have you tried typing values into the numeric bar for heigth and
radius whilst creating?
Check your units (under preferences). Try making it cm or something small.
Apply a grid that is some knowable form of that unit. Zoom in til you
know what scale you're at.
Try turning snap to grid off. Try turning off 'lock to imput plane.
I don't know. Good luck.
:o)
chris
Keirn Hilleary wrote:
OK, I will try to see if replacing with an older file will work . . .
Reloading SP3 unfortunately didn’t do the trick. I’ll let you know
what I find out.
Thanks Again
Keirn
-----Original Message-----
*From:* [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] *On Behalf Of *Neil Cooke
*Sent:* Wednesday, January 17, 2007 9:17 PM
*To:* [email protected]
*Subject:* Re: Cylinder Creation Failure
I think something here can be set in preferences ... perhaps the
number of decimal places ... I mostly use between four and ten but
whatever. If the default value has been over written somehow to
0.0000000000 then maybe reload SP3 to re-write that. But I'm only
guessing. Another dodge might be to open an old file that has the
value as 0.1 then load without replacing your faulty file into it.
Then, also you could delete everything and save the file as your
start-up file. This too might reset that value.
