Hi All, Thanks for the help! I just compile version 1.2.1 and it is working now. It seem the wavecom modem got a little problems with the CVS version -20030109.
Best Regards, Randal > Hi Steven, > > I am using the CVS version cvs-20030109, I think I should try the stable > version now. > > Thanks alot for the help! > > Randal > >> What version you are using? >> >> I am using Wavecom modem, but a WMOD2B GSM Modem. >> >> It is working fine in my system, but I am using Kannel >> 1.0.5 >> >> Steven Mak >> --- Randal Law <[EMAIL PROTECTED]> wrote: >>> Dear Nil, >>> >>> Thanks again! Yes I can use a normal phone to send >>> and receive sms message. >>> >>> Attach are my conf. files, pls help! >>> >>> Best Regards, >>> Randal >>> >>> > I use AT commands now with thye same modem as >>> yours and everything works >>> > fine. >>> > To be sure that the problem comes from kannel, try >>> to send and receive a >>> > sms using a normal phone. >>> > If it works then show me your kannel.conff file >>> > >>> > regards >>> > >>> > -----Original Message----- >>> > From: Randal Law [mailto:[EMAIL PROTECTED]] >>> > Sent: dimanche 12 janvier 2003 09:21 >>> > To: [EMAIL PROTECTED] >>> > Cc: [EMAIL PROTECTED] >>> > Subject: RE: Wavecom Modem >>> > >>> > Dear Nil, >>> > >>> > Thanks for the reply! But my phone operator setup >>> is OK. So I think I >>> > have >>> > another problems :( >>> > >>> > In your smsc group, are you using "at2" or "at"? >>> Do you need to set >>> > "need-sleep = true"? >>> > >>> > Anyone also using wavecom fastrack modem WMOM2, >>> pls help! I just afarid >>> > kannel doesnt support this modem :( >>> > >>> > Best Regards, >>> > Randal >>> > >>> >> Hi Randal >>> >> >>> >> I had a similar problem. >>> >> In my case it was due to the chip card of the >>> phone operator that >>> > wasn't >>> >> properly setup. >>> >> I had to put it in a phone and reset it up with >>> the right sms operator >>> >> phone number. >>> >> >>> >> Regards >>> >> >>> >> Nil >>> >> >>> >> -----Original Message----- >>> >> From: [EMAIL PROTECTED] >>> > [mailto:[EMAIL PROTECTED]] >>> >> On Behalf Of Randal Law >>> >> Sent: vendredi 10 janvier 2003 17:54 >>> >> To: [EMAIL PROTECTED] >>> >> Subject: Wavecom Modem >>> >> Importance: High >>> >> >>> >> Hi All, >>> >> >>> >> I am using a Wavecom Fastrack WMOD2 Mobile modem. >>> It seem kannel >>> >> successfully initial the modem. But when It >>> sending sms message its >>> > got >>> >> error, please help! Thanks! >>> >> >>> >> bearerbox.log show below: >>> >> 2003-01-10 15:58:51 [0] INFO: >>> ---------------------------------------- >>> >> 2003-01-10 15:58:51 [0] INFO: Kannel bearerbox II >>> version cvs-20030109 >>> >> starting >>> >> 2003-01-10 15:58:51 [0] INFO: MAIN: Start-up >>> done, entering mainloop >>> >> 2003-01-10 15:58:51 [0] DEBUG: AT2[/dev/ttyS0]: >>> start called >>> >> 2003-01-10 15:58:51 [7] DEBUG: sms_router: >>> list_len = 0 >>> >> 2003-01-10 15:58:51 [14] DEBUG: Started thread 16 >>> >> (gw/bb_boxc.c:function) >>> >> 2003-01-10 15:58:51 [16] INFO: Client connected >>> from <127.0.0.1> >>> >> 2003-01-10 15:58:51 [16] DEBUG: setting up >>> systems for new wapbox >>> >> 2003-01-10 15:58:51 [16] DEBUG: Started thread 17 >>> >> (gw/bb_boxc.c:boxc_sender) 2003-01-10 15:58:52 >>> [6] DEBUG: >>> >> AT2[/dev/ttyS0]: >>> >> device opened >>> >> 2003-01-10 15:58:52 [6] INFO: AT2[/dev/ttyS0]: >>> init device >>> >> 2003-01-10 15:58:52 [6] INFO: AT2[/dev/ttyS0]: >>> speed set to 9600 >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT^M >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT&F^M >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> ATE0^M >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+IFC=2,2^M >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CPIN?^M >>> >> 2003-01-10 15:58:52 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- +CPIN: READY >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CMGF=0^M >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CSMS=?^M >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- +CSMS: (0,1) >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:59:03 [6] INFO: AT2[/dev/ttyS0]: >>> Phase 2+ is supported >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CSMS=1^M >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- +CSMS: 1,1,1 >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> >>> > AT+CNMI=1,2,0,1,0^M >>> >> 2003-01-10 15:59:03 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- OK >>> >> 2003-01-10 15:59:03 [6] INFO: AT2[/dev/ttyS0]: AT >>> SMSC successfully >>> >> opened. 2003-01-10 15:59:10 [5] DEBUG: >>> boxc_receiver: sms received >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> TP-Validity-Period: >>> > 24.0 >>> >> hours >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CMGS=16^M >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- > >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> send command status: 1 >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> >>> >> 0011000881592197680000A704E8321B0E >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> ^Z >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- > >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- ERROR >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> send command status: >>> > -1 >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CMGS=16^M >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- > >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> send command status: 1 >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> >>> >> 0011000881592197680000A704E8321B0E >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> ^Z >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- > >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- ERROR >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> send command status: >>> > -1 >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> AT+CMGS=16^M >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> <-- > >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> send command status: 1 >>> >> 2003-01-10 15:59:11 [6] DEBUG: AT2[/dev/ttyS0]: >>> --> >>> >> 0011000881592197680000A704E8321B0E >>> >> === message truncated === >> >>> ATTACHMENT part 2 application/octet-stream >> name=kannel.conf >> >> >>> ATTACHMENT part 3 application/octet-stream >> name=modems.conf >> >> >>> ATTACHMENT part 4 application/octet-stream >> name=wapbox.conf >> >> >> >> __________________________________________________ >> Do you Yahoo!? >> Yahoo! Mail Plus - Powerful. Affordable. Sign up now. >> http://mailplus.yahoo.com *********************************** OZtel Limited (An OZtell subsidiary) 1104 Chevalier House, 45-51 Chatham Road Tsim Sha Tsui, HONG KONG Tel: (852) 2312-0180 Fax: (852) 2312-0182 Website: www.oztell.com ***********************************
