On Tue, Feb 12, 2013 at 10:27 PM, Moti Asayag wrote: > > You should follow the next steps: > > 1. Create a new logical network from the networks main tab: define its > data-center and set its vlan-id to 50 (the VM network checkbox should be > checked) > 2. Click on the created network in the networks main tab ---> Select the > 'Clusters' sub-tab and ---> click on 'Assign/Unassign Network' and > attach the network to the cluster (which contains the hosts that are > expected to run the VMs). > 3. Click on 'hosts' sub-tab of the network main tab for the same > network. You should be able to see the cluster's hosts. Select a host > and click on 'Setup Networks'. > 4. In the 'setup networks' dialog you would see the host's interfaces on > the left side and the logical networks definition on the right. > Drag the network on top of an interface, or first drag a nic on top of > another to create a bond and then drag the network to that bond. > A command will be sent from the engine to the vdsm on the host to > configure the desired network configuration. > 5. In order to persist the network configuration on the host you can > check the 'save network configuration' from 4.
Hello, I followed these steps to create a bonded VM network (no vlan tagging) with 3.2 beta. Only differences - assignement of network to cluster (step 2) can also be completed while in step 1) - step 3 : to see the host and setup networks for it you have to select the "unattached" check box I don't understand if and how I can put lan parameters if I don't use vlan tagging I don't see any option for that, when I edit the "network" itself or go through the "setup host networks" For example the VMs that will attach to this new network that I called "client" will have ip of the form 10.10.10.x/24 with gw 10.10.10.1 and eventually I would like to give an ip address to the created bond itself. Can I? Thanks, Gianluca _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
