----- Original Message ----- > On Tue, Feb 12, 2013 at 10:27 PM, Moti Asayag wrote: > > > > > You should follow the next steps: > > > > 1. Create a new logical network from the networks main tab: define > > its > > data-center and set its vlan-id to 50 (the VM network checkbox > > should be > > checked) > > 2. Click on the created network in the networks main tab ---> > > Select the > > 'Clusters' sub-tab and ---> click on 'Assign/Unassign Network' and > > attach the network to the cluster (which contains the hosts that > > are > > expected to run the VMs). > > 3. Click on 'hosts' sub-tab of the network main tab for the same > > network. You should be able to see the cluster's hosts. Select a > > host > > and click on 'Setup Networks'. > > 4. In the 'setup networks' dialog you would see the host's > > interfaces on > > the left side and the logical networks definition on the right. > > Drag the network on top of an interface, or first drag a nic on top > > of > > another to create a bond and then drag the network to that bond. > > A command will be sent from the engine to the vdsm on the host to > > configure the desired network configuration. > > 5. In order to persist the network configuration on the host you > > can > > check the 'save network configuration' from 4. > > Hello, > I followed these steps to create a bonded VM network (no vlan > tagging) > with 3.2 beta. > Only differences > - assignement of network to cluster (step 2) can also be completed > while in step 1) > > - step 3 : to see the host and setup networks for it you have to > select the "unattached" check box > > I don't understand if and how I can put lan parameters if I don't use > vlan tagging > I don't see any option for that, when I edit the "network" itself or > go through the "setup host networks"
Hi, Can you please explain what do you mean by "lan parameters" that you're trying to set? > > For example the VMs that will attach to this new network that I > called > "client" will have ip of the form > 10.10.10.x/24 with gw 10.10.10.1 > > and eventually I would like to give an ip address to the created bond > itself. Can I? You can specify IP & Netmask statically on the interface that you attach the network to on the host. During the setup networks command you can see a "pencil" button on the network which is on an interface (bond or NIC), click it and then you can see the boot protocol options. > > Thanks, > Gianluca > _______________________________________________ > Users mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/users > _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
