#1 I grabbed a power source for mine at the fuse block under the fake tank
by the seat. Use a test light to make sure you are using a fuse that is hot
only when key is on.
#2 Yes you can install a simple switch to manually hold your vboost in the on
position. Under your left scoop look for a 3 wire plug, unplug it and cycle
the key switch to make sure the vboost stops working this way you will be
sure you have the right one. Plug it back in and cut the black wire and wire
it thru a standard single pole switch. When the switch is in the on position
the vboost will operate as stock.
When you first turn on the key listen for the vboost to open then turn off
the switch , this will kill power to the servo motor leaving the boost on.
Some members say that the springs may pull the vboost back closed a little
but my bike the servo stays exactly where you shut it off. Cost is about $
2.00 and takes about 15 min.
good luck
scott mellor
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
