Steve,
Weird things always happen to you ... sigh ... I think the very best
picture of the shift forks and the "pins" that Don is referring to is
on the parts microfiche at HLSM. Of course the shift cam actually
makes the forks move in the correct direction to manipulate the gears
and each fork has a little leg that runs in it's respective track on
the shift cam. It sounds like the "little" fork may have lost it's
guide pin and longer cares what the shift cam is doing ... I am
assuming that when you push "down" on the lever past neutral that the
lever does actually move. Of course if the little snap pins that Don
is referring to have done something bad then I don't think you would
be able to move the shift cam past a certain point ....... sooooo ...
either condition sounds like it could cause the situation you are
describing. Anyhow .. take a good look at these pictures .. they
reveal much more that the manual.
campbell
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
