Rick - The needle slides out of the base with the little positioner on it. The
washer goes between the clip and the base.
Scott
VMOA #500
[EMAIL PROTECTED] wrote:
> I have a 2000 max and last Friday my local bike shop agreed to help me shim
> my needles. A slow day for them and they had done lots of older max bikes.
> When they pulled the needles out to add the shim, wow, the needle design
> had been changed from what they had previously seen. The needle taper was
> tapered and not relatively flat and worst of all, the area to place the
> shim/washer now has a little positioner tab and does not allow a washer to be
> added for shimming. He was very reluctant to do any change to the needle
> itself, so just richened up the carb misxtures and dumped the oem plugs for
> some good ngk s. But what about the 2000 max, what is this needle design
> change. Do I have to go to a jet kit??
>
> Rick/Decatur
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
