I started over, told it not to use mixed case symbols, and after about 4.25 hours it appears to have completed successfully. Now to start the tests....
On Sun, Dec 23, 2012 at 2:01 PM, Craig A. Berry <craigbe...@mac.com> wrote: > > On Dec 23, 2012, at 12:52 PM, Thomas Pfau <tfp...@gmail.com> wrote: > > > Some defaults aren't restored properly when re-executing configure.com. > > > > Enable thread upcalls? [n] y > > Installation prefix to use (for PERL_ROOT)? [ perl_root.] ] > dsa0:[perl-5_16_2_root.] > > What pager is used on your system? [type/pag] type/page=save=10 > > The intention is that it will read the config.sh generated by a previous > configuration if it exists and use it as your new set of defaults. This is > in imitation of what Configure does. If you don't want that behavior, you > need to make the realclean target before reconfiguring, which will removing > any existing config.sh files. > > ________________________________________ > Craig A. Berry > mailto:craigbe...@mac.com > > "... getting out of a sonnet is much more > difficult than getting in." > Brad Leithauser > > -- Thomas Pfau tfp...@gmail.com http://www.linkedin.com/in/thomaspfau http://nbpfaus.net/~pfau/
