You can clearly see in the video there were a volt meter and amp meter
at the wall plug measuring the energy delivered to the Blue Box and
another set between the Blue Box and the E-Cat. According to the Higgins
data, power input was measured many times during the self sustain mode.
Are you suggesting ALL the people in the room during the most
interesting time, the self sustain mode did not glance at all 4 meters?
There is no way Rossi could have faked the input power. Too many people
and sets of eyes there to check the 4 meters. They were not restricted
in access to the E-Cat. Many went up and felt the water boiling. If
think they did not also glance at the 4 sets of meters as well? Come on
Peter, they were ALL skeptical. They came to see the power output versus
the power input. They felt the E-Cat boiling water and they checked the
openly visible meters to make sure there was no power applied to the
E-Cat. They knew they were watching history in the making. Checking
those 4 sets of meters with their eyes and feeling the water boiling
inside the E-Cat was what they did to eliminate their skepticism. They
knew that to continue boiling water, with no reduction in temperature
for 4.5 hours and to SEE with their own eyes that there was no power
being applied, they were seeing the dawn of a new age. Fool a few?
Maybe? Fool everybody in the room? No way. You think he fooled Paul
Swanson from SPAWAR?
The same thing applies to the earlier Kullander test / demo. Those guys
were not fools. They would have been looking for any sign of fraud. They
found none. In the end, Rossi removed all the insulation so they could
see there was nothing but a small door knob sized reactor that produced
around 24 kWs of heat and peaked at 130 kWs.
On 12/11/2011 11:24 AM, Peter Heckert wrote:
Am 11.12.2011 01:46, schrieb Aussie Guy E-Cat:
This is silly. There was a clamp on amp meter on the mains cord and
on the heater wires going into the E-Cat. Power consumption was
recorded during the self power run. Refer to the Higgins data. Are
you suggesting that during the self powering period NONE of the MANY
people in the room would have failed to see the clamp on amp meter
showing high levels of power consumption? Also present was the LENR
guy from SPAWAR. There is no way power could have been supplied to
the E-Cat heaters without someone seeing the amps meter increase.
Just not possible.
Look here: http://youtu.be/NNCuLAZKvL4
I dont see a meter that seems to be capable to record data without a
realtime computer connection.
I dont remember if any amperage recording instruments where mentioned
in the report.
Peter