On Tuesday, September 19, 2017 at 7:54:35 AM UTC-4, Damjan Hajsek wrote: > > About preassure, I use absolute preassure which is higher than sea level > preassure, my altitude is 293m (I have this setting in weewx.conf). When I > checked my absolute preassure it was about 1008mbar until sea level was I > think about 995mbar. But I have always set to absoulte preassure and when > is absoulte preassure 1010mbar weewx shows 1008 mbar. >
run weewx directly. post the output from a few LOOP packets. for each LOOP packet you post, also post the value for pressure that was displayed on the console at the time of that LOOP packet. > Rain starts to show up after about 25 minutes but need to be calibrated > value is too high. I have hardware to measure rain rate. Console show rain > rate 18mm/h until in real is about 4mm/h. you can see on vreme.povej.net > please post the [StdWXCalculation] section of your weewx configuration. post the output from a few LOOP packets. for each LOOP packet you post, also post the value for rain rate that was displayed on the console. m -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
