here it is from weewx.conf and on link packets
http://zerobin.povej.net/?2b67951062395755#msXGtrC6ARHSBTBUCDj5qdeV920nG2FzZbloR3nozAI=

[StdWXCalculate]
    
    [[Calculations]]
        # Derived quantities are calculated by this service. Possible 
values are:
        #  hardware        - use the value provided by hardware
        #  software        - use the value calculated by weewx
        #  prefer_hardware - use value provide by hardware if available,
        #                      otherwise use value calculated by weewx
        
        pressure = prefer_hardware
        barometer = prefer_hardware
        altimeter = prefer_hardware
        windchill = prefer_hardware
        heatindex = prefer_hardware
        dewpoint = prefer_hardware
        inDewpoint = prefer_hardware
        rainRate = prefer_hardware

##############################################################################

Dne torek, 19. september 2017 14.25.29 UTC+2 je oseba mwall napisala:
>
>
>
> On Tuesday, September 19, 2017 at 7:54:35 AM UTC-4, Damjan Hajsek wrote:
>>
>> About preassure,  I use absolute preassure which is higher than sea level 
>> preassure, my altitude is 293m (I have this setting in weewx.conf). When I 
>> checked my absolute preassure it was about 1008mbar until sea level was I 
>> think about 995mbar. But I have always set to absoulte preassure and when 
>> is absoulte preassure 1010mbar weewx shows 1008 mbar.
>>
>
> run weewx directly.  post the output from a few LOOP packets.  for each 
> LOOP packet you post, also post the value for pressure that was displayed 
> on the console at the time of that LOOP packet.
>
>  
>
>> Rain starts to show up after about 25 minutes but need to be calibrated 
>> value is too high. I have hardware to measure rain rate. Console show rain 
>> rate 18mm/h until in real is about 4mm/h. you can see on vreme.povej.net
>>
>
> please post the [StdWXCalculation] section of your weewx configuration.
>  
> post the output from a few LOOP packets.  for each LOOP packet you post, 
> also post the value for rain rate that was displayed on the console.
>
> m
>

-- 
You received this message because you are subscribed to the Google Groups 
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/d/optout.

Reply via email to