Is anyithing new about this topic?

Dne torek, 19. september 2017 21.33.19 UTC+2 je oseba Damjan Hajsek 
napisala:
>
> here it is from weewx.conf and on link packets
>
> http://zerobin.povej.net/?2b67951062395755#msXGtrC6ARHSBTBUCDj5qdeV920nG2FzZbloR3nozAI=
>
> [StdWXCalculate]
>     
>     [[Calculations]]
>         # Derived quantities are calculated by this service. Possible 
> values are:
>         #  hardware        - use the value provided by hardware
>         #  software        - use the value calculated by weewx
>         #  prefer_hardware - use value provide by hardware if available,
>         #                      otherwise use value calculated by weewx
>         
>         pressure = prefer_hardware
>         barometer = prefer_hardware
>         altimeter = prefer_hardware
>         windchill = prefer_hardware
>         heatindex = prefer_hardware
>         dewpoint = prefer_hardware
>         inDewpoint = prefer_hardware
>         rainRate = prefer_hardware
>
>
> ##############################################################################
>
> Dne torek, 19. september 2017 14.25.29 UTC+2 je oseba mwall napisala:
>>
>>
>>
>> On Tuesday, September 19, 2017 at 7:54:35 AM UTC-4, Damjan Hajsek wrote:
>>>
>>> About preassure,  I use absolute preassure which is higher than sea 
>>> level preassure, my altitude is 293m (I have this setting in weewx.conf). 
>>> When I checked my absolute preassure it was about 1008mbar until sea level 
>>> was I think about 995mbar. But I have always set to absoulte preassure and 
>>> when is absoulte preassure 1010mbar weewx shows 1008 mbar.
>>>
>>
>> run weewx directly.  post the output from a few LOOP packets.  for each 
>> LOOP packet you post, also post the value for pressure that was displayed 
>> on the console at the time of that LOOP packet.
>>
>>  
>>
>>> Rain starts to show up after about 25 minutes but need to be calibrated 
>>> value is too high. I have hardware to measure rain rate. Console show rain 
>>> rate 18mm/h until in real is about 4mm/h. you can see on vreme.povej.net
>>>
>>
>> please post the [StdWXCalculation] section of your weewx configuration.
>>  
>> post the output from a few LOOP packets.  for each LOOP packet you post, 
>> also post the value for rain rate that was displayed on the console.
>>
>> m
>>
>

-- 
You received this message because you are subscribed to the Google Groups 
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/d/optout.

Reply via email to