Thank you for helping.
I will use StdCalibrate to get exact value of solar radiation.
About preassure,  I use absolute preassure which is higher than sea level 
preassure, my altitude is 293m (I have this setting in weewx.conf). When I 
checked my absolute preassure it was about 1008mbar until sea level was I 
think about 995mbar. But I have always set to absoulte preassure and when 
is absoulte preassure 1010mbar weewx shows 1008 mbar.
Rain starts to show up after about 25 minutes but need to be calibrated 
value is too high. I have hardware to measure rain rate. Console show rain 
rate 18mm/h until in real is about 4mm/h. you can see on vreme.povej.net



Dne torek, 19. september 2017 13.38.51 UTC+2 je oseba mwall napisala:
>
>
>
> On Tuesday, September 19, 2017 at 4:10:08 AM UTC-4, Damjan Hajsek wrote:
>>
>> I have updatetd now again and Solar Radiation show about 35% more than it 
>> is real, but rain Rate is now 0.
>> Also have noticed that preassure shows on weewx about 0002 less than it 
>> is, when it is 1010mbar on console in weewx shows 1008mbar
>>
>>>
> use StdCalibrate to adjust solar radiation.  as i said before, the 
> conversion from lux to W/m^2 is an approximation.  if you want the weewx 
> output to match that of the console, you will have to figure out what 
> algorithm the console firmware uses, then put that into StdCalibrate.
>
> regarding pressure, are you comparing apples to apples?  is the console 
> reporting gauge pressure or sea level pressure?  what is the station 
> altitude?
>
> 'rain Rate is now 0' is not helpful.  is it always 0?  what *should* it 
> be?  is there always a discrepancy, or just for certain values of rain? 
>  are you using software or hardware for rain rate?  what is the raw output 
> from the station when rain rate in weewx is not the same as rain rate on 
> the console?
>
> m
>

-- 
You received this message because you are subscribed to the Google Groups 
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/d/optout.

Reply via email to