5V is only an issue with the Airgrids....the others (Rockets and Nanos ) 
are using 24v or 15v power supplies.
And yes, if you are using the Airgirds, pay attention to the cable run....

Faisal.

On 4/14/2010 11:41 AM, Robert West wrote:
> Pay attention to your cable runs as well.  That 5v PoE sucks, I've been
> using variable voltage adapters into a power injector and adjust the voltage
> depending on how it's acting.  Sometimes, if the voltage is on the low side
> for the cable run, the unit will power up but act "stupid" but if I hit it
> with another volt or 2 it behaves.
>
> Bob-
>
>
> -----Original Message-----
> From: [email protected] [mailto:[email protected]] On
> Behalf Of RickG
> Sent: Wednesday, April 14, 2010 11:34 AM
> To: WISPA General List
> Subject: Re: [WISPA] UBNT "M" Was: Ubiquiti made no points today
>
> Upgraded to version 5.1.2 prior to installation. Still poor
> performance. Not using Mimo mode. Using as an AP on a repeater. Having
> no luck connecting to it with another M unit as CPE. Think its a bad
> radio(s)?
>
> On Wed, Apr 14, 2010 at 11:12 AM, Michael Baird<[email protected]>  wrote:
>    
>> Bad firmware and poor compatibility with legacy protocols. Make sure you
>> upgrade them to the absolute latest beta available on the forums.
>>
>> Regards
>> Michael Baird
>>      
>>> I've been using regular Bullets and NS2's which have been working
>>> great. So, I thought I'd give the "M" units a try. So far, nothing but
>>> poor signal, dropped packets,&    low throughput. Replacing them with
>>> regular units fix the issue. What gives?
>>>
>>> On Tue, Apr 13, 2010 at 8:01 PM, Forbes Mercy
>>> <[email protected]>    wrote:
>>>
>>>        
>>>> After falling in like with the Rocket M Nano's the Rocket M Bullets and
>>>> the Mimos I have to say I'm firmly unimpressed with the integrated
>>>> antenna series.  We bought a pack of 10 of the 27dbi grids, not one of
>>>> them would associate to our Mimos yet a bullet and in some cases, where
>>>> distance wasn't a factor, the Nano Rockets did so without a problem.  We
>>>> just took delivery on the Nano Dish units, we wanted them to do some
>>>> short range backhauls.
>>>>
>>>> Today was our first, replacing a 10MB Motorola backhaul at 5.2 miles, we
>>>> set up the new dishes up in the office WDS on, WPA on they connected at
>>>> -50 (as they should in the office), connection firm all night.
>>>> Installed them today, the AP working well we headed up the mountain to
>>>> install the other one.  It would not see or connect to the other Nano
>>>> Dish no matter whether we used the lower powered 5.2 or the more
>>>> generous 5.7/8 frequency range.  Gradually turning off the WDS, then the
>>>> WPA, then making it 20 MHZ, finally we gave up and the unnecessary
>>>> beating to my bucket truck that had to climb that mountain left me in a
>>>> pretty foul mood over the new gear.  I'm about to RMA all of it and go
>>>> back to just bullets and Rockets.
>>>>
>>>> Forbes
>>>>
>>>>
>>>>
>>>>          
> ----------------------------------------------------------------------------
> ----
>    
>>>> WISPA Wants You! Join today!
>>>> http://signup.wispa.org/
>>>>
>>>>          
> ----------------------------------------------------------------------------
> ----
>    
>>>> WISPA Wireless List: [email protected]
>>>>
>>>> Subscribe/Unsubscribe:
>>>> http://lists.wispa.org/mailman/listinfo/wireless
>>>>
>>>> Archives: http://lists.wispa.org/pipermail/wireless/
>>>>
>>>>
>>>>          
>>>
>>>        
> ----------------------------------------------------------------------------
> ----
>    
>>> WISPA Wants You! Join today!
>>> http://signup.wispa.org/
>>>
>>>        
> ----------------------------------------------------------------------------
> ----
>    
>>> WISPA Wireless List: [email protected]
>>>
>>> Subscribe/Unsubscribe:
>>> http://lists.wispa.org/mailman/listinfo/wireless
>>>
>>> Archives: http://lists.wispa.org/pipermail/wireless/
>>>
>>>        
>>
>>
>>
>>      
> ----------------------------------------------------------------------------
> ----
>    
>> WISPA Wants You! Join today!
>> http://signup.wispa.org/
>>
>>      
> ----------------------------------------------------------------------------
> ----
>    
>> WISPA Wireless List: [email protected]
>>
>> Subscribe/Unsubscribe:
>> http://lists.wispa.org/mailman/listinfo/wireless
>>
>> Archives: http://lists.wispa.org/pipermail/wireless/
>>
>>      
>
> ----------------------------------------------------------------------------
> ----
> WISPA Wants You! Join today!
> http://signup.wispa.org/
> ----------------------------------------------------------------------------
> ----
>
> WISPA Wireless List: [email protected]
>
> Subscribe/Unsubscribe:
> http://lists.wispa.org/mailman/listinfo/wireless
>
> Archives: http://lists.wispa.org/pipermail/wireless/
>
>
>
> --------------------------------------------------------------------------------
> WISPA Wants You! Join today!
> http://signup.wispa.org/
> --------------------------------------------------------------------------------
>
> WISPA Wireless List: [email protected]
>
> Subscribe/Unsubscribe:
> http://lists.wispa.org/mailman/listinfo/wireless
>
> Archives: http://lists.wispa.org/pipermail/wireless/
>
>    


--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
 
WISPA Wireless List: [email protected]

Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless

Archives: http://lists.wispa.org/pipermail/wireless/

Reply via email to