Forbes, so are you saying: if I change and go to a Rocket with Airmax dual pol 
antenna and I have a client with a UBNT Bullet M2 HP Connected to a Laird 24Dbi 
Grid Vertical only dish, that even though the Bullet has Airmax as part of it, 
it wont connect.  Or are you saying that all your clients need to be new with 
Airmax ability?

Steve Barnes
General Manager
PCS-WIN<http://www.pcswin.com/>
RC-WiFi Wireless Internet Service<http://www.rcwifi.com/>

From: [email protected] [mailto:[email protected]] On Behalf 
Of Forbes Mercy
Sent: Monday, September 13, 2010 2:11 PM
To: WISPA General List
Subject: Re: [WISPA] Taking the plunge

>From personal experience I can tell you that you will be very happy when you 
>make the switch.  I just replaced three Mikrotik BH/AP units, pings went from 
>their rather wild 30-120ms swings to a steady 15ms no matter what time.  Just 
>be ready for three things, you can't put usernames in the ACL like Mikrotik, 
>there is less routing because UBNT expects filtering to be done in your router 
>before their equipment, and it will never go down because it's just a 
>transparent bridge so traffic that would have overwhelmed Mikrotik equipment 
>and crashed the LAN port won't happen on Ubiquity.  Oh and you're right, I've 
>found that if you use dual-polarity you can't mix that with non-dual and 
>connections with non-, its far better to have all Airmax running rather than a 
>mix, this means replacing CPE so that all customers on that tower are the same 
>equipment, spendy (relative to UBNT's low cost) but worth it.

Forbes Mercy
Washington Broadband

On 9/13/2010 10:31 AM, Steve Barnes wrote:
All my APs are Mikrotik. My CPE’s are a mix of Tranzeo and UBNT.   I have a AP 
with 58 Clients on it and starting to get complaints about slowdowns.  They are 
all setup 10 MHz channel 802.11g.  This is a tower that due to contractual 
issues I cannot add anymore equipment.  So I am considering taking down the 
Mikrotik and 120 degree sector and putting up a UBNT Rocket and Airmax 120 
sector.  It will take time to physically switch all my clients to new UBNT 
Airmax equipment but would like to get it done before the snow flies.

Has anyone down this?  Success?  I know I cannot turn on Airmax till everyone 
is on the UBNT with that capability but does it work fine till you get it on?

Steve Barnes
RC-WiFi Wireless Internet Service<http://www.rcwifi.com/>









--------------------------------------------------------------------------------

WISPA Wants You! Join today!

http://signup.wispa.org/

--------------------------------------------------------------------------------



WISPA Wireless List: [email protected]<mailto:[email protected]>



Subscribe/Unsubscribe:

http://lists.wispa.org/mailman/listinfo/wireless



Archives: http://lists.wispa.org/pipermail/wireless/


--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
 
WISPA Wireless List: [email protected]

Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless

Archives: http://lists.wispa.org/pipermail/wireless/

Reply via email to