Apologies if this is not the correct place to ask... I've searched Google but can't find a solution.
Using WSJT-X v1.8.0 r8193 and an AOR AR3030 receiver. In File/Settings/Radio I select AOR AR3030, Baude rate 4800, 8 data bits, 2 stop bits, no handshake. I press "4800 ENT" on the receiver and it enters "REMOTE" mode. I click on Test CAT and the "REMOTE" on the receiver LCD goes out and I get the error "Rig Failure Hamlib error:Protocol error while getting current VFO frequency" The receiver works with Hyperterm. I can change modes, download settings like filter, AGC, frequency, mode etc. If, back in WSJT-X I select other AOR receivers... With the receiver tuned to 7.076 MHz I didn't expect the following to work, but tried them anyway. AOR AR7030 "Test CAT" works (it doesn't give the Hamlib error) but shows the wrong frequency (11,402.646 569) in WSJT-X, and WSJT-X doesn't control the receiver. AOR AR7030 Plus "Test CAT" also works (it doesn't give the Hamlib error) but shows the frequency as 0.000 000 and again WSJT-X doesn't control the receiver. Hopefully somebody has a suggestion of how to proceed. Is it something I'm doing wrong or a bug in the software? Barry (G4IAT) -- ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
