On 03/08/2018 11:40 PM, Barry Smith wrote:

Hi Barry,

WSJT-X is using hamlib and according to hamlib, the support of the
AR3030 is untested. I suggest you to examine the documentation of your
rig in order to find the acceptable values for the command below.

Then is suggest you to use, at first, the rigctl utility which is part
of the hamlib package, in order to see what is working well and what is
not. For details, see the hamlib documentation. Please use a command like...

/usr/local/bin/rigctl -m505 --send-cmd-term=";"
--setconf=rig_pathname=/dev/rig,serial_speed=4800,dcd_type=RIG,timeout=500,retry=2,write_delay=5,post_write_delay=50,itu_region=1

...in order to enter the manual command entry mode. Please change the
above command in order to make it conform to your environment and to
your rig. At first, while in this test mode, you can enter the "?"
command in order to see the available commands. At next, ask the used
VFO, the frequency, the mode, etc.

Best wishes,
Claude


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel

Reply via email to