Hi, while that may work it's in my view better to find the source of any
RFI and get rid of it.
You never know what else it might be doing!
Try the setup on a dummy load and if it's then OK look at the
antenna/feeder arrangement.
Alan G0TLK, sent from my mobile device
On 24 September 2021 23:50:24 Ari Paananen via wsjt-devel
<wsjt-devel@lists.sourceforge.net> wrote:
Hi Daniel,
Sounds like RF from your own transmissions is getting through to
the RasPi and disabling the USB-ports. Installing snap-on ferrites
to both ends of the USB-cables, Raspi power-wire and any other
possible connections might help.
On 25.9.2021 1:19, Bill Somerville via wsjt-devel wrote:
On 24/09/2021 23:09, Daniel Uppström via wsjt-devel wrote:
Hi,
On my Raspberry Pi 3 32 bit I get WSJT-X to stop the waterfall in
FT-8 mode after I initiate a transmission. When the program starts
the waterfall shows the FFT data as it should so I don't think this
is a performance issue. But when transmitting, it just stops and
doesn't start again until I restart the program.
I have asked this question earlier this year but didn't get a reply.
Now I updated to WSJT-X 2.4.0 but the exact same problem is still
there.
Any thoughts?
Daniel / SM6VFZ
Hi Daniel,
that may be an RFI issue, is your audio link to the rig using a USB
interface?
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
--
Avast Antivirus on tarkistanut tämän sähköpostin virusten varalta.
https://www.avast.com/antivirus
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
