Re: [wsjt-devel] Waterfall stops on Raspberry Pi

Mon, 15 Aug 2022 05:30:19 -0700

On 8/15/22 14:23, Steve Platt wrote:
On 15 August 2022 13:58:25 CEST, "Daniel Uppström via wsjt-devel" <wsjt-devel@lists.sourceforge.net> wrote:
Hi all,
I still experience this problem, described below. Now tested on WSJT-X v2.5.4 under Linux Mint.
Waterfall stops updating after TX. Without any radio connected at all. So not an RFI issue.
Am I the only one that has seen this problem?

Thanks,
Daniel
SM6VFZ


On 9/25/21 20:43, Daniel Uppström wrote:
Thank you for several suggestions about RFI, but unfortunately it is not. I get the same result without any radio connected whatsoever.

Daniel
SM6VFZ



On 9/25/21 11:27 AM, Alan via wsjt-devel wrote:
Hi, while that may work it's in my view better to find the source of any RFI and get rid of it.  

You never know what else it might be doing!

Try the setup on a dummy load and if it's then OK look at the antenna/feeder arrangement.

Alan G0TLK, sent from my mobile device

On 24 September 2021 23:50:24 Ari Paananen via wsjt-devel <wsjt-devel@lists.sourceforge.net> wrote:

Hi Daniel,

Sounds like RF from your own transmissions is getting through to
the RasPi and disabling the USB-ports. Installing snap-on ferrites
to both ends of the USB-cables, Raspi power-wire and any other
possible connections might help.


On 25.9.2021 1:19, Bill Somerville via wsjt-devel wrote:
On 24/09/2021 23:09, Daniel Uppström via wsjt-devel wrote:
Hi,
On my Raspberry Pi 3 32 bit I get WSJT-X to stop the waterfall in 
FT-8 mode after I initiate a transmission. When the program starts 
the waterfall shows the FFT data as it should so I don't think this 
is a performance issue. But when transmitting, it just stops and 
doesn't start again until I restart the program.
I have asked this question earlier this year but didn't get a reply. 
Now I updated to WSJT-X 2.4.0 but the exact same problem is still 
there.

Any thoughts?

Daniel / SM6VFZ

Hi Daniel,

that may be an RFI issue, is your audio link to the rig using a USB 
interface?

73
Bill
G4WJS.



_______________________________________________
wsjt-devel mailing list



-- 
Avast Antivirus on tarkistanut tämän sähköpostin virusten varalta.



_______________________________________________
wsjt-devel mailing list



_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel



Are you using the same audio device for Rx and for Tx? EG using "pulse" for both?

I have found that doing so gives the results you describe; also that one of the threads goes into a loop so that you have to kill the process.
-- Sent from my Android device with K-9 Mail. Please excuse my brevity.
Thanks, but this does not matter for me. It still freezes with different devices selected.
Good to hear that you see the / a smlilar problem though!

/Daniel
 



_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel






















					Reply via email to