A very quick initial report from my test. Running the 2.92 test in a VM, using the settings I described in the how-to I wrote a few weeks ago. Basically, 368mb ram and virtual IDE disk.
On the agree/disagree section, I would change the wording to "I agree..." rather than "I do agree..." The "I do not agree..." is fine by the way - just that in English, I agree is more usual than I do agree ;) OK, so the basic setup seems to proceed OK - usual errors about powernow, which I don't worry too much about, although I can list them if you like Tobias! Eventually, I get to the command line and run the script to start the installer - which begins the CLI install. So far so good. But.... it then fails to detect the virtual hdd :( Attempting to use setup afterwards from the command line tells me "installcd is not properly running" . Not sure exactly what the issue is as yet! BTW, that phrase is not good English - maybe changing the words properly running around to read running properly would be better, although the whole phrase is not very clear. Does it mean the CD (virtual in my case) has an issue, or the drive is not working or ....? Will report further once I have fiddled a little more! Should the cd actually be installable at the moment? Perhaps the failure to detect the hdd is purely down to the detection not being enabled in the test iso? Mark _______________________________________________ yoper-dev mailing list [email protected] https://morpheus.pingos.org/cgi-bin/mailman/listinfo/yoper-dev
