On Jun 6, Roberto Spadim <[email protected]> wrote: > hum, you must check if your serial-ethernet allow change o baud rate, Yes, I can change baud rate via telnet on the box. The serial data is passed via another port (e.g. 1000, freely defined).
> rts, cts, etc... using only one port, this is the 'telnet' protocol Those pins are unused in my 1wire adaptor (only power stealing). So I really only need RX/TX > in raw mode for example, you will never change baud rate, only > changing parameters of box, or a file... with 'telnet' protocol you > can change it without disconnecting and changing a file or a > webpage... > do you have the manual or datashhet of your serial-ethertnet box? Yes, this one: http://www.precidia.com/downloads/user_guides/Ether232PlusUser_02-CML000057.pdf (I have an Ether232 Solo, but it seems to be identical in firmware) thanks! Markus -- __________________ /"\ Markus Gaugusch \ / ASCII Ribbon Campaign markus(at)gaugusch.at X Against HTML Mail / \ ------------------------------------------------------------------------------ Simplify data backup and recovery for your virtual environment with vRanger. Installation's a snap, and flexible recovery options mean your data is safe, secure and there when you need it. Discover what all the cheering's about. Get your free trial download today. http://p.sf.net/sfu/quest-dev2dev2 _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
