I am running the 3-27 snapshot of pfsense.
I've been testing out adding a 2nd OPT interface that goes to remote
sites over a wireless link. A dedicated access point is doing all the
wireless stuff, so that is not a responsibility of the pfsense box.
Here's my problem though.
I can ping remote hosts from the pfsense box and can ping the remote
hosts from the LAN interface. Remote hosts show up in my arp table on
the pfsense box and remote hosts can see the pfsense box in their arp
tables. I have a firewall rule configured to all all traffic going into
and coming out of the interface on the pfsense box (Once I get things
working, I'll lock this down some).
Firewall Rule:
Proto * Source * Destination * Port * Gateway *
The firewall log shows that the pfsense box is accepting inbound
requests, but nothing happens. The remote hosts can't ping the pfsense
machine, connect to it in any way, or access resources that lie behind it.
I do not have a NAT rule set for this interface, and I'm using Advanced
NAT. I don't want to perform NAT on this interface, just routing.
The IP of the OPT interface on the pfsense box is 172.16.125.1/24 with
no gateway defined for the interface. All of the remote hosts are in
the 172.16.125.0/24 subnet and they have the pfsense box set up as their
default gateway. The diagnostic => routes page shows the correct
interface as for the route to the 172.16.125.0/24 network and also shows
a route to each host.
Am I missing something that I need to have configured that I don't? My
other OPT interface to a dsl connection is working correctly.
Thanks,
Vaughn
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
