No, this is just my bench setup for now. So no surge suppressors,
bonding and stuff to make things more confusing.
Honestly, I've just been using the on-board GPS on the ePMP stuff until
now, mostly because we've been doing omni micro-POP sites or one or two
sectors. But we're going to start doing more full clusters and I want
everything at the same site on the same timing source.
And I don't know WTF is going on, but I can't seem to find APC PRM24's
anywhere. Found some on Amazon only to have the seller tell us their
stock was wrong and they don't have any. Now we've had some on order for
weeks from Solid Signal. Apparently they don't have stock either, so
they said they'd drop ship from Tessco or something like that. And.....
they're waiting on them from Schneider/APC. Bastards. So that's mostly
why I've had two RackInjectors sitting in my office doing nothing and I
figured I'd at least power them up and play around. As if I don't have
enough other shit to do.
On 1/9/2018 10:33 PM, Steve Jones wrote:
i have a set not syncing off the powerinjector, im thinking its that
all the radio grounds ar bonded top and bottom and the pipe is also,
so is an equal ground plane with too long a run, its freaking it out
some how, havent gone to unbond the tops yet
im assuming the guts are essentially the same between powerinjector
and rev 1 rack injector
On Tue, Jan 9, 2018 at 9:59 PM, George Skorup
<[email protected] <mailto:[email protected]>> wrote:
So, the ePMP 2k ships with a passive POE brick that's +4/5 -7/8,
48VDC. That's how I have the port on the RackInjector jumpered.
Radio is set to sync source = CMM3. Status shows CMM Sync Down.
Now the obvious question is, I'm guessing I needs it to be -4/5
+7/8 like traditional Canopy? The 2k is 802.3at compliant, so I'm
guessing that will be fine. But the OEM brick is different. I
assume the answer is yes, but I don't want to blow things up.
Unless I'm doing something else wrong. The RackInjector shows sync
and yes, the sync pulse is enabled on the port.
Probably another question is, will the 2k support "Cambium Sync"
like the 450i and 450m? Or are they going to make us wait for the 3k?
