I would likely use "sipsak", which is a command line tool for crafting sip messages. It says in that PDF that only warning codes 300 to 399 are supported. 399 is the generic warning parameter (see the SIP RFC3261, section 20.43 on 'Warning'), so it would likely go something like this (I have not tried it yet):
sip endpoint: [EMAIL PROTECTED]:5060 sip endpoint password: abc123 sip server: 192.168.0.20:5060 192.168.0.100 ---- echo 'NOTIFY sip:[EMAIL PROTECTED]:5060 SIP/2.0 Via: SIP/2.0/UDP 192.168.0.20 From: <sip:[EMAIL PROTECTED]> To: <sip:[EMAIL PROTECTED]> Warning: 399 192.168.0.20 "The sky is falling" Date: blah Call-ID: [EMAIL PROTECTED] CSeq: 1300 NOTIFY Contact: <sip:[EMAIL PROTECTED]> Content-Length: 0 ' | sipsak -v -f - -s sip:[EMAIL PROTECTED]:5060 -G -a abc123 ---- On Thu, Oct 30, 2008 at 12:04 PM, Elliott Jeyaseelan <[EMAIL PROTECTED]> wrote: > Anyone? > >> -----Original Message----- >> From: Elliott Jeyaseelan [mailto:[EMAIL PROTECTED] >> Sent: Sunday, October 26, 2008 2:07 PM >> To: Toronto Asterisk UG >> Subject: [on-asterisk] Polycom 3.1 firmware pop-up >> notification on phones display >> >> Hi, >> >> I was going thru the new 3.1 series of polycom firmware for >> the soundpoint series IP phones, (301/501/550 etc) and on >> page 4-72 of the Sip 3.1 administrators guide, there is a >> very short blurp about how to display a 3 second notification >> on the polycom phone's display via sip header. >> >> Has any tried this or have a clue on how to do this from asterisk 1.4? >> >> The pdf can be viewed from the following link if anyone is >> interested in checking this out, I would be very interested >> to know how to put up a server generated message on the >> phones display sent from asterisk either triggered by an >> event, time or other: >> >> http://www.polycom.com/common/documents/support/setup_maintena >> nce/produc >> ts/voice/spip_ssip_Admin_Guide_SIP_3_1.pdf >> >> Thanks for any suggestions or ideas. >> >> Elliott >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [EMAIL PROTECTED] For >> additional commands, e-mail: [EMAIL PROTECTED] >> >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > -- | It ain't what you don't know that gets you into trouble. It's what | you know for sure that just ain't so. -- Mark Twain | | The Toronto Asterisk Users Group | Join the discussion group by visiting http://taug.ca --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
