Ruggiero wrote: > thanks for informations,i followed your suggestions...but i think i'm > missing something...here there are other informations: > > [EMAIL PROTECTED] ~]# ifconfig > eth0 Link encap:Ethernet HWaddr 00:16:D4:DF:*:* > UP BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > Interrupt:21 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:8602 errors:0 dropped:0 overruns:0 frame:0 > TX packets:8602 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:69166424 (65.9 MiB) TX bytes:69166424 (65.9 MiB) > > wlan0 Link encap:Ethernet HWaddr 00:19:7E:84:*:* > inet addr:192.168.1.80 Bcast:192.168.1.255 Mask:255.255.255.0 > UP BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > wmaster0 Link encap:UNSPEC HWaddr > *19-7E-84-*D3-D8-98-00-00-00-00-00-00-00-00 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > > [EMAIL PROTECTED] ~]# iwconfig > lo no wireless extensions. > > eth0 no wireless extensions. > > wmaster0 no wireless extensions. > > wlan0 IEEE 802.11g ESSID:"***** > Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated > Retry min limit:7 RTS thr:off Fragment thr=2346 B > Encryption key:****************************************** > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > [EMAIL PROTECTED] ~]# iwlist scan > lo Interface doesn't support scanning. > > eth0 Interface doesn't support scanning. > > wmaster0 Interface doesn't support scanning. > > wlan0 Scan completed : > Cell 01 - Address: *0C:41:19:2D:* > ESSID:"" > Mode:Master > Channel:11 > Frequency:2.462 GHz > Quality=204/146 Signal level=-206 dBm Noise > level=-67 dBm > Encryption key:on > Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s > Extra:tsf=0000000012e26229 > > thanks again for helping
Fedora 7 offers the possibility of controlling your interface with NetworkManager, which I find much easier to use that ifup/ifdown, etc. The current version does require using dynamic IP's, not a static value. Is that possible for you? Now that your wireless interface is up, please send a new copy of 'dmesg | grep bcm'. Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
