can't i use static ip address?because all the lan is set up without dhcp [EMAIL PROTECTED] ~]# dmesg|grep bcm bcm43xx_mac80211: Broadcom 4311 WLAN found bcm43xx_mac80211: Found PHY: Analog 4, Type 2, Revision 8 bcm43xx_mac80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 bcm43xx_mac80211: Radio turned off bcm43xx_mac80211: Adding Interface type 2 bcm43xx_mac80211: Loading firmware version 351.126 (2006-07-29 05:54:02) bcm43xx_mac80211: Radio turned on bcm43xx_mac80211: Radio enabled by hardware bcm43xx_mac80211: !WARNING! Idle-TSSI phy->cur_idle_tssi measuring failed. (cur=21, tgt=62). Disabling TX power adjustment. bcm43xx_mac80211: Chip initialized bcm43xx_mac80211: 32-bit DMA initialized bcm43xx_mac80211: Wireless interface started bcm43xx_mac80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
----- Original Message ----- From: "Larry Finger" <[EMAIL PROTECTED]> To: "Ruggiero" <[EMAIL PROTECTED]> Cc: "Ehud Gavron" <[EMAIL PROTECTED]>; <[email protected]> Sent: Thursday, November 08, 2007 6:42 PM Subject: Re: BCM94311MCG > Ruggiero wrote: >> thanks for informations,i followed your suggestions...but i think i'm >> missing something...here there are other informations: >> >> [EMAIL PROTECTED] ~]# ifconfig >> eth0 Link encap:Ethernet HWaddr 00:16:D4:DF:*:* >> UP BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) >> Interrupt:21 >> >> lo Link encap:Local Loopback >> inet addr:127.0.0.1 Mask:255.0.0.0 >> inet6 addr: ::1/128 Scope:Host >> UP LOOPBACK RUNNING MTU:16436 Metric:1 >> RX packets:8602 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:8602 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:0 >> RX bytes:69166424 (65.9 MiB) TX bytes:69166424 (65.9 MiB) >> >> wlan0 Link encap:Ethernet HWaddr 00:19:7E:84:*:* >> inet addr:192.168.1.80 Bcast:192.168.1.255 Mask:255.255.255.0 >> UP BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) >> >> wmaster0 Link encap:UNSPEC HWaddr >> *19-7E-84-*D3-D8-98-00-00-00-00-00-00-00-00 >> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) >> >> >> [EMAIL PROTECTED] ~]# iwconfig >> lo no wireless extensions. >> >> eth0 no wireless extensions. >> >> wmaster0 no wireless extensions. >> >> wlan0 IEEE 802.11g ESSID:"***** >> Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated >> Retry min limit:7 RTS thr:off Fragment thr=2346 B >> Encryption key:****************************************** >> Link Quality:0 Signal level:0 Noise level:0 >> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 >> Tx excessive retries:0 Invalid misc:0 Missed beacon:0 >> >> [EMAIL PROTECTED] ~]# iwlist scan >> lo Interface doesn't support scanning. >> >> eth0 Interface doesn't support scanning. >> >> wmaster0 Interface doesn't support scanning. >> >> wlan0 Scan completed : >> Cell 01 - Address: *0C:41:19:2D:* >> ESSID:"" >> Mode:Master >> Channel:11 >> Frequency:2.462 GHz >> Quality=204/146 Signal level=-206 dBm Noise >> level=-67 dBm >> Encryption key:on >> Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s >> Extra:tsf=0000000012e26229 >> >> thanks again for helping > > Fedora 7 offers the possibility of controlling your interface with > NetworkManager, which I find much easier to use that ifup/ifdown, etc. The > current version does require using dynamic IP's, not a static value. Is > that possible for you? > > Now that your wireless interface is up, please send a new copy of 'dmesg | > grep bcm'. > > Larry > > -- Io utilizzo la versione gratuita di SPAMfighter per utenti privati. Sino ad ora ha rimosso 821 mail spam. Gli utenti paganti non hanno questo messaggio nelle loro email . Prova gratuitamente SPAMfighter qui:http://www.spamfighter.com/lit _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
