<https://lh3.googleusercontent.com/-JJzoRGronFw/Wc0snO3IbZI/AAAAAAAACA0/2H72v88J278HrZVfGDhznal6ExRxamSowCLcBGAs/s1600/x15_sata.jpg>
Hello Gerald, Thank you for the quick reply. Can you review the image attached and confirm this is what I should do? Please refer to highlights in bright green. Any suggestions on unsoldering R444? Looks impossibly microscopic to remove or even unsolder without doing damage to the contiguous components. Thanks Marc On Thursday, September 28, 2017 at 10:24:02 AM UTC-5, gcoley1 wrote: > > Check the schematic Page 13. There is a table showing where the jumpers go > to affect the booting sequence. All you have to do is solder a wire into > those holes to change the setting. For SATA you just need to install one > wire in J3 position 1-2 and remove R444. The lines in read show the default > which is set by the resistors onboard. > > > > Gerald > > > > > > *From:* [email protected] <javascript:> [mailto: > [email protected] <javascript:>] *On Behalf Of * > [email protected] <javascript:> > *Sent:* Thursday, September 28, 2017 9:44 AM > *To:* BeagleBoard <[email protected] <javascript:>> > *Subject:* [beagleboard] X15 Boot via USB > > > > Hello, > > I just purchased an X15 and the EMMC memory is rapidly filling up. > > 1. Is there a way to boot from an external USB hard drive? > or > 2. Can someone provide more detail directions on switching boot sequence > to boot directly from eSATA? > The reference manual is very vague on this. You need to unsolder and > resolder resistors to act as jumpers? There are perforated holes in the > circuit board where the resistors and jumpers are supposed to be. Are the > resistors supplied? Are they on the board? If so where are they? What are > their values in Ohms? How are the perforations on the board numbered 1-3 > from left to right or right to left? This needs to be much more detailed. > Why would you design a board that make switching the boot sequence so > difficult? How about just putting in some removable jumpers! > > Any detailed help and direction would be appreciated. > > Thanks > > MAB > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/888427c3-b40f-45c3-a38c-ba6e0bc7fbba%40googlegroups.com > > <https://groups.google.com/d/msgid/beagleboard/888427c3-b40f-45c3-a38c-ba6e0bc7fbba%40googlegroups.com?utm_medium=email&utm_source=footer> > . > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/33e0e445-f4f5-4d0e-bcdc-ed0a366dbcbb%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
