Sounds like I may missing something. I'm assuming u-boot would be on the debian image written to the SATA drive via dd? Do I need to install this separetly? The Beagle Bone Black is pretty straight foreward with good documentation. The X15 is not. Are there any more detailed instructions on-line that can take me through the install/boot process via eSATA. The reference manual documentation is not adequate.
Thanks for your help. Marc On Sunday, October 1, 2017 at 8:31:13 AM UTC-5, gcoley1 wrote: > > I doubt you have fried it, but sounds like the SW is not writing to a > register that keeps the board active, something that was put in place due > to a silicon bug in the HW. I suspect you do not have the correct UBoot or > it is not reading the SATA correctly. It will time out and then shutdown. > > > > Gerald > > > > > > *From:* [email protected] <javascript:> [mailto: > [email protected] <javascript:>] *On Behalf Of * > [email protected] <javascript:> > *Sent:* Saturday, September 30, 2017 8:47 PM > *To:* BeagleBoard <[email protected] <javascript:>> > *Subject:* Re: [beagleboard] X15 Boot via USB > > > > Hello Gerald, > > I removed the resistor and placed a jumper between J3 1-2 attached a sata > drive with a new debian image written via dd and am unable to boot. I'm > getting a blank screen and the power LED comes on and the LED between the > power connector and the RAM illuminates for just a few seconds and goes > off. The status LEDs never illumitate. Am I fogetting something or did I > just fry my X15? > > Thanks > > Marc > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/2eee952e-243c-422c-8edc-4dc1017c49eb%40googlegroups.com > > <https://groups.google.com/d/msgid/beagleboard/2eee952e-243c-422c-8edc-4dc1017c49eb%40googlegroups.com?utm_medium=email&utm_source=footer> > . > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/60c4236b-c3af-4a77-817a-3c11f90bca87%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
