I received the SD card with Keysoft 7 on today and followed the instructions. All seemed to go as planned except that I did not hear the word Loadinbg after the last reset. Not that easy to do by the way holding down the J and L and pressing reset with a pen, I am sure there must have been a simpler key combination than that. Anyway I left the device alone for 10 minutes to see if it was doing the loading anyway and after a while it did do a rest so I assumed it had completed its installation. However it still says version 6,2 version 25. I tried going through the whole process again but with the same result. The who;e experience so far is far from user centred. This is the sort of installation procedure I would expect to do as a programmer but not as a userm especially a blind user. There are some additional instructions in the trouble shooting section which involved renaming files but I don't want to get into deep water there unless I really have to. Any suggestions at this point?
Graham Lewis Centre for Academic Practice University of Warwick University House Kirby Corner Road Coventry CV4 8UW UK Tel.: (+44) (0) 24 765 72737 Mobile: 07733450022 Fax.: (+44) (0) 24 765 727326 http://www2.warwick.ac.uk/services/cap/about/staff/lewis/ http://innovations.warwick.ac.uk/innovations/ http://cap.warwick.ac.uk/tdf ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
