That looks like the problem. I can see an air bubble in there.Remove the tube. If there is enough slack cut off the kink and reattach the hose
On Thu, Dec 2, 2010 at 10:25 AM, HowardG <[email protected]> wrote: > OK I uploaded the picture just now to the photo area -- it's called > "kink" (original, no?) > > On Dec 2, 1:07 pm, HowardG <[email protected]> wrote: >> I took off the cover and traced the supply line all the way into the >> machine, past the three-way coupling and saw that there is a kink in >> the hose where it is attached to the brass nipple of (what I assume to >> be) the pump -- I took a photo of it -- is there a way to post a pic >> to this group? >> >> On Dec 2, 12:50 pm, Ira <[email protected]> wrote: >> >> > At 07:32 AM 12/2/2010, you wrote: >> >> > >This morning the same >> > >routine: temp stabilizes at 200, brew pressure gauge reads 10 bars. I >> > >pull one shot (again a long extraction time) and the brew pressure >> > >gauge falls to and stays at 0 the temp starts to climb. While this is >> > >happening I hear a gurgling noise from inside the machine. >> >> > Sounds almost like 2 problems, an overpressure valve that sticks open >> > and a defective or badly set up PID. Can you go through all the PID >> > settings and make sure they are the same as factory recommended. >> >> > I keep trying to figure out if a loose wire or a couple of swapped >> > wires would cause this, but I don't really see how. >> >> > When you pull the second shot with a blind disk and get no pressure >> > is the water returning to the tank? Does water come out of the short >> > hose or do you notice the pressure on the steam boiler changing? Is >> > the water in the steam boiler hot? >> >> > Ira > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/brewtus?hl=en. > > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en.
