Hello Ian, Wednesday, July 10, 2013, 10:00:23 AM, you wrote:
Hi Ira, thanks for the response. I was able to look at the wire and found no marks on it. I did however notice a small cut on the gray 'cap' that sits right above the hex head that screws into the boiler. (this is where the wires pass through) I wonder if this could be the cause of the erratic reading. If you're comfortable working around electricity, turn it on and after a bit gently move the wire and see if that effects the reading. The hot ticket for a test like that is to move a small bend along the length of the wire. Not enough to actually bend it, just so you know you've checked every inch of the wire.If you have a ohm meter you could also check the resistance of the sense wire and the resistance of the sense element to ground. -- Ira -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/groups/opt_out.
