You can do: show run int virtual-access XXX
It probably won't list it in there though. You can inject it into the interface via RADIUS using the Cisco-AVpair attribute Cisco-AVPair = "lcp:interface-config#1=service-policy output llq-policy" FYI, those users are technically PPPoVPDN - PPPoE and PPPoA users have a different template. Gregory Boehnlein wrote: > Hello, > We have a 7206 running (C7200-IK9S-M), Version 12.3(20), RELEASE > SOFTWARE (fc2). We are trying to get LLQ implemented on Virtual Template > interfaces for our PPPoE DSL users: > > vpdn-group akrnaa01rr > description SBC Akron VPDN Group > accept-dialin > protocol l2tp > virtual-template 1 > terminate-from hostname akrnaa01rr.oh.AADS > local name xxxxxx > lcp renegotiation always > l2tp tunnel password 7 xxxxxxxxxxx > > interface Virtual-Template1 > mtu 1492 > ip unnumbered Loopback1 > rate-limit output access-group 102 8000 1500 2000 conform-action transmit > exceed-action drop > no ip route-cache cef > no ip route-cache > no logging event link-status > peer default ip address pool ppp > keepalive 5 > compress stac > ppp max-bad-auth 5 > ppp authentication pap > ppp chap refuse > service-policy output llq-policy > end > > It seems to take it fine, but when I do a "show policy-map interfaces" I get > the following output; > > Virtual-Template1 > > Service-policy output: llq-policy > > Service policy content is displayed only for cloned interfaces only such > as vaccess and sessions > > I can't tell if this means that the service-policy is not enabled for the > interface, or if it just doesn't show up. Any ideas? > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
