Seth,
can you post line by line (including creation of the ACL list number)
the commands you are entering?
Maybe even a sanitized config?
What IOS version are you running?
Billy
Seth Mattinen wrote:
I just got this confusing error message with an IPv6 ACL:
% This ACL contains following unsupported entries.
% Remove those entries and try again.
permit tcp any host 2607:FE70:0:1:2C0:F0FF:FE5A:ABE8 sequence 30
% This ACL can not be attached to the interface.
This platform is a 3750 switch, but I thought EUI-64 formatted hosts
were supported (they were in the past anyway), so now I'm confused.
Anyone know why this was rejected by the switch?
~Seth
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
