On 6/21/2010 19:14, Billy Guthrie wrote: > Seth, > > can you post line by line (including creation of the ACL list number) > the commands you are entering? > Maybe even a sanitized config? > What IOS version are you running? >
Full sequence of commands, too: switchy-core1>enable Password: switchy-core1#copy tftp://whiskers/acl/timmy-6 run Destination filename [running-config]? Accessing tftp://whiskers/acl/timmy-6... Loading acl/timmy-6 from 208.79.242.34 (via Vlan7): ! [OK - 472 bytes] 472 bytes copied in 0.294 secs (1605 bytes/sec) switchy-core1#conf ter Enter configuration commands, one per line. End with CNTL/Z. switchy-core1(config)#int Fa1/0/3 switchy-core1(config-if)#ipv6 traffic-filter fw-timmy_6-out out % This ACL contains following unsupported entries. % Remove those entries and try again. permit tcp any host 2607:FE70:0:1:2C0:F0FF:FE5A:ABE8 eq smtp sequence 30 % This ACL can not be attached to the interface. switchy-core1(config-if)#^Z switchy-core1#show ipv6 access-list fw-timmy_6-out IPv6 access list fw-timmy_6-out permit icmp any 2607:FE70:0:1::/64 sequence 10 permit tcp any 2607:FE70:0:1::/64 established sequence 20 permit tcp any host 2607:FE70:0:1:2C0:F0FF:FE5A:ABE8 eq smtp sequence 30 permit tcp any host 2620:0:950:1:2C0:F0FF:FE5A:ABE8 eq smtp sequence 40 switchy-core1# _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
