Try adding 6 to the allowed list on the trunk. --
Sent from my mobile device On 2013-04-09, at 12:16 AM, Mike <[email protected]> wrote: > Hi, > > > I would like to be able to accept both tagged and untagged frames on my > 3560g. For the untagged frames, I'd like to be able to say these are a member > of some vlan - say 100 - otherwise I want to be able to allow tagged frames > from some list. > > In testing, it doesn't appear that "switchport trunk native vlan xxxx" is > doing the job; anything I send untagged is dropped and doesn't show up in the > switch mac address tables. Here is my config: > > interface GigabitEthernet0/45 > description testing cisco vlans > switchport trunk encapsulation dot1q > switchport trunk native vlan 6 > switchport trunk allowed vlan 306 > switchport mode trunk > > > It it helps. I do also have dot1q native vlan tagging enabled. I just can't > see inside of the switch and understand where my frames are going. If I put > it into switchport mode access, and switchport access vlan 6, it all works > fine and I see mac addresses in the table. > > Any help would be appreciated. > > Mike- > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
