Nevermind... Mid-read the initial config. --
Sent from my mobile device On 2013-04-09, at 12:23 AM, Jason Lixfeld <ja...@lixfeld.ca> wrote: > Try adding 6 to the allowed list on the trunk. > > -- > > Sent from my mobile device > > > On 2013-04-09, at 12:16 AM, Mike <mike-cisconspl...@tiedyenetworks.com> wrote: > >> Hi, >> >> >> I would like to be able to accept both tagged and untagged frames on my >> 3560g. For the untagged frames, I'd like to be able to say these are a >> member of some vlan - say 100 - otherwise I want to be able to allow tagged >> frames from some list. >> >> In testing, it doesn't appear that "switchport trunk native vlan xxxx" is >> doing the job; anything I send untagged is dropped and doesn't show up in >> the switch mac address tables. Here is my config: >> >> interface GigabitEthernet0/45 >> description testing cisco vlans >> switchport trunk encapsulation dot1q >> switchport trunk native vlan 6 >> switchport trunk allowed vlan 306 >> switchport mode trunk >> >> >> It it helps. I do also have dot1q native vlan tagging enabled. I just can't >> see inside of the switch and understand where my frames are going. If I put >> it into switchport mode access, and switchport access vlan 6, it all works >> fine and I see mac addresses in the table. >> >> Any help would be appreciated. >> >> Mike- >> _______________________________________________ >> cisco-nsp mailing list cisco-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/