Hey folks
On my project CRX the bolt which hold the altertaor to the engine so that it can pivot to tighten the belt has rusted to to the alternator. There is a metal sleeve whichis rusted to the bolt. does any one have any tip and ricks to get this out.
I have tried heat, pentrant, brute force (5 lb sledge with 2'ft rebar so I can really wail away at it) I have even gotten destructive with my dremel and a cutoff disc but due to space limitations it can't cut any deeper ino the alternator
I guess my next step might be tro try a drill and drill perpendicular into the bolt and alternator. I guess at this point I have already lost my core deposit so I have nothing more to lose.
Any suggestions?
(* snip *)
You may be able to cut it free from the lower bracket and then just replace the bracket once you free it from the block. I don't know what the cost is on a new bracket and it probably will be a dealer only part (unless you can get one from a local salvage yard). You'll also have to get two new bushings and a lower bolt too.
I suppose you could snap or cut the nut off, then either drill or try and drive the rest of the bolt out. The lower bolt is just a through bolt (squared at one end and a nut which is used to secure it on the other).
This probably doesn't help, but here's my tech article on how to R&R an alternator..
Best of luck and let us know what you end up doing...
CRX Owners Group President (http://www.crx.org/southcal)
1990 Honda CRXsi (http://www.hooligan.cc)
ICQ # 3714283 (nickname: godzilla)
Julian Drive (San Diego County) - February 22, 2003
http://www.crx.org/southcal/events.html
