Hello Lionel, Apologies for delayed reply. I was trying all my options before raising an issue.
I'm attaching my installation steps. Please let me know what's wrong with them. Regards Ashwin From: [email protected] <[email protected]> On Behalf Of Lionel Liu Sent: 10 April 2018 18:11 To: [email protected]; Ashwini Kumar Gupta <[email protected]> Subject: Re:RE: Can't get output after creating measure Hi Ashwini, It works the same in linux OS, we need to check the log to figure out what happened, it might be some configure mistake or input mistake. I recommend you try our docker image first, by following this doc: https://github.com/apache/incubator-griffin/blob/master/griffin-doc/docker/griffin-docker-guide.md -- Regards, Lionel, Liu At 2018-04-10 19:25:01, "Ashwini Kumar Gupta" <[email protected]<mailto:[email protected]>> wrote: >Hello Lionel, > >I'm running this in cloudera VM. Will that change anything? > >Regards >Ashwin > >From: Lionel Liu <[email protected]<mailto:[email protected]>> >Sent: 10 April 2018 15:26 >To: [email protected]<mailto:[email protected]>; >Ashwini Kumar Gupta ><[email protected]<mailto:[email protected]>> >Subject: Re: Can't get output after creating measure > >Hi Ashwini, > >First, you could check the log of griffin service, to know if it has triggered >the job instance. >Then, griffin service will submit a spark application with configuration to >livy, you can check the log of livy, to verify if it has been submitted >correctly. >After that, you need to check the spark cluster, to verify the application has >been accepted by the cluster, if it runs, you can get the application log >through yarn. > >Each step error might block the result. > >Thanks, >Lionel > >On Tue, Apr 10, 2018 at 5:01 PM, William Guo ><[email protected]<mailto:[email protected]<mailto:[email protected]%3cmailto:[email protected]>>> > wrote: >hi Ashwin, > >Could you show us your log here? > >Thanks, >William > >On Tue, Apr 10, 2018 at 3:35 PM, Ashwini Kumar Gupta < >[email protected]<mailto:[email protected]<mailto:[email protected]%3cmailto:[email protected]>>> > wrote: > >> Hello Team, >> >> I have been trying to install and use griffin but I cannot get output when >> I click on DQ Matrix. >> >> I created a measure, created a job to run. >> The sequence in which I run all services are: >> >> >> 1. Elasticsearch >> 2. Jar file >> >> I also noticed that griffin is not creating mapping in ES. >> >> Can you please tell me where I'm going wrong. >> >> Thanks >> Ashwin >> >
Griffin installing steps.docx
Description: Griffin installing steps.docx
