Hi, Fabrice I am testing using HT20 for all my secured mesh setup. So the tx rate is 104Mbps and above.
Did you ever try the HT mode and run into "out of memory" problem? I think that the problem happened because of HT mode used by my secured mesh node. Regards, Chun-Yeow On Tue, Dec 6, 2011 at 12:39 AM, Fabrice Deyber <[email protected] > wrote: > Hi Chun-Yeow, > > > Your results look promising. Is this based on open80211s-0.5 release >> after >> applying the ath9k patch that I posed? Did you ever try out HT20 or HT40 >> for multi-hop scenario after applying the patch I posed? You have >> mentioned >> before "I changed to minstrel and the problem went away". Can you >> elaborate >> this. >> > > I'm using open80211s-0.5 with the HW encryption patch. I have not tried HT > modes. > I also changed the rate control algorithm in config.mk from "ath9k" to > "minstrel". > When you dump the stations with iw, what tx rate do you see? > If the nodes are close to each other you should see 54 Mbps (or whatever > you expect in HT mode) on all the nodes. > > --Fabrice > >
_______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
