Check an auto parts store (e.g. O'Rielly). They have silicone-based
gasket material in tubes that you just smear on, then tighten the parts.
Standard stuff. Sorry it's not very sexy - no laser cutting, not 3D
printing. What can I say?
On 4/9/2015 7:01 AM, Jason Plumb wrote:
What about using sculpey or a similar clay or putty that cures at room
temp? Makes me wonder if there is one that doesn't cure as solid as
sculpey...
Maybe that as a first step and then some caulk to finish it up?
On April 9, 2015 4:45:45 AM PDT, Paul Stoffregen <[email protected]> wrote:
On 04/09/2015 12:51 AM, Pavel Kirkovsky wrote:
What application is the gasket for? Is plain old gasket paper
unsuitable?
Mostly for making water and dust resistant electronics enclosures. When
I say "dust", think 40 MPH winds in a white-out at Burning Man....
------------------------------------------------------------------------
dorkbotpdx-blabber mailing list
[email protected]
http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
_______________________________________________
dorkbotpdx-blabber mailing list
[email protected]
http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
No virus found in this message.
Checked by AVG - www.avg.com <http://www.avg.com>
Version: 2012.0.2250 / Virus Database: 4311/8993 - Release Date: 04/09/15
No virus found in this message.
Checked by AVG - www.avg.com <http://www.avg.com>
Version: 2012.0.2250 / Virus Database: 4311/8993 - Release Date: 04/09/15
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
dorkbotpdx-blabber mailing list
[email protected]
http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
