"Terrell Hamilton" <[EMAIL PROTECTED]> made an utterance to the drakelist gang ---------------------------------------------------------------------- Jim - You mentioned seeing Garey's picture - is Electric Radio still in print?
Terry K7WLD -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jim Theisen Sent: Saturday, January 26, 2008 11:41 AM To: [EMAIL PROTECTED] Subject: Re: [drakelist] Re: T4X frequency check Jim Theisen <[EMAIL PROTECTED]> made an utterance to the drakelist gang ---------------------------------------------------------------------- Ok Thanks Garey Yep the old mind transposed once again. Yes the crystal is grounded just fine. This is a new xtal. I suppose now I need to pad C2 some how. The crystal in my R-4A receiver was off by a lot and the new one was right on. When I ordered them I made sure I got a pair that was temperature oriented in such a way to keep the Tx Rx pair with the same drift characteristics as was mentioned in one of your articles I read somewhere. Actually the old T4X crystal was closer to 5645 then the new one. Any other ideas would be helpful. I enjoyed seeing your picture in the Electric Radio. Boy you're a young handsome devil!!! Thanks Jim Garey Barrell wrote: > > Garey Barrell <[EMAIL PROTECTED]> made an utterance to the > drakelist gang > ---------------------------------------------------------------------- > Jim - > > I hope you mean 5646.11 kHz !! > > Be sure the MODE switch is NOT in CW when you are trying to set the > frequency. If OK, then be sure that the crystal terminal connected to > C1 is actually grounded. > > C6 is for the balanced modulator, and will have to be set as described > in Section IV, C of the manual. > > 73, Garey - K4OAH > Glen Allen, VA > > Drake 2-B, 4-B & C-Line Service Supplement CDs > <www.k4oah.com> > > > > Jim Theisen wrote: >> >> Jim Theisen <[EMAIL PROTECTED]> made an utterance to the drakelist >> gang >> ---------------------------------------------------------------------- >> Hi Drake Experts >> / >> /I have put a new 5645 xtal in my T-4X transmitter and using the C2 >> cap can only get the frequency to 4546.11. >> >> Is this normal and is it close enough. I needed to install a 5595 >> xtal in my R-4A and it came on freq just fine. >> >> What is the C6 cap by T-14 used for I see no changes in any readings >> when turned. >> >> Thanks >> >> Jim >> >> WB8REH >> > > ---------------------------------------------------------------------- > Submissions: [EMAIL PROTECTED] > Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in > body > Hopelessly Lost: [EMAIL PROTECTED] - help in body of message > Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net > ---------------------------------------------------------------------- > > > ---------------------------------------------------------------------- Submissions: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ---------------------------------------------------------------------- ---------------------------------------------------------------------- Submissions: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ----------------------------------------------------------------------
