Wes, Can you toggle between HI/LO and SHIFT/WIDTH when in SSB mode? I can shift between the two in all data modes except FSK D where they stay in SHIFT/WIDTH.
Just wondering if your K3 is broken. 73, Don W3FPR On 12/16/2010 3:29 PM, Wes Stewart wrote: > Don, and I'll reply to Monty here too, > > There is no question that I'm in Data A and my HI and LO controls do not > function. I seldom use PSK, I prefer RTTY, but I'm sure that this didn't > happen in the past. Just for giggles I rolled back my firmware to 4.0 > sumptin' and I had the same issue. > > I generally leave the VFO set for example to 14.070 and click tune on the > waterfall, but use HI and LO cut to select the signal of interest. As it > stands the SHIFT range is so limited that I can't isolate lower tones. > > Wes > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
