Don, Yes, in SSB I can toggle between Shift/Width to Lo/Hi.
In data modes I cannot. I never paid attention to AFSK A before since I use 915 Hz for Mark and I never found it necessary to change the default shift of 1 KHz or to toggle to Lo/Hi. Here is a clue for the guys I hope start looking into this. I cannot toggle filter modes in CW either *if PB CTRL is set to .01, but can toggle if PB CTRL is set to .05.* Unfortunately, this isn't a fix for the data modes. Wes N7WS --- On Thu, 12/16/10, Don Wilhelm <[email protected]> wrote: > Wes, > > Can you toggle between HI/LO and SHIFT/WIDTH when in SSB > mode? > I can shift between the two in all data modes except FSK D > where they > stay in SHIFT/WIDTH. > > Just wondering if your K3 is broken. > > 73, > Don W3FPR > > On 12/16/2010 3:29 PM, Wes Stewart wrote: > > Don, and I'll reply to Monty here too, > > > > There is no question that I'm in Data A and my HI and > LO controls do not function. I seldom use PSK, I > prefer RTTY, but I'm sure that this didn't happen in the > past. Just for giggles I rolled back my firmware to > 4.0 sumptin' and I had the same issue. > > > > I generally leave the VFO set for example to 14.070 > and click tune on the waterfall, but use HI and LO cut to > select the signal of interest. As it stands the SHIFT > range is so limited that I can't isolate lower tones. > > > > Wes ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
