The KPA only talks on the Auxbus, it does not listen. So yes, the four BAND signals are needed.
Jack Brindle, W6FB Sent from my iPhone > On Jan 20, 2014, at 5:23 PM, Phil Theis <[email protected]> wrote: > > In the KPA cable going to the K3 the band data lines are called out, yet > there is no discussion about instructing the K3 firmware to set band data. > My band data is used for transverters with Config:KIO3 set to TRN. If these > lines are not used and band information is derived from AUXBUS, then do we > really need the four band lines in the cable going from KPA to K3? > thanks, > Phil K3TUF > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
