Thanks Jack, then I must be changing my KIO3 Setting back and forth
between TRN and Normal based on HF use or VHF use? right
Phil K3TUF
On 1/20/2014 8:28 PM, Jack Brindle wrote:
The KPA only talks on the Auxbus, it does not listen. So yes, the four BAND
signals are needed.
Jack Brindle, W6FB
Sent from my iPhone
On Jan 20, 2014, at 5:23 PM, Phil Theis <[email protected]> wrote:
In the KPA cable going to the K3 the band data lines are called out, yet there
is no discussion about instructing the K3 firmware to set band data. My band
data is used for transverters with Config:KIO3 set to TRN. If these lines are
not used and band information is derived from AUXBUS, then do we really need
the four band lines in the cable going from KPA to K3?
thanks,
Phil K3TUF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
