Phil, Could use use the HF-TRN setting of the BAND outputs? (Page 19 of the K3 owner's manual, right column, first paragraph.)
This setting was specifically included to handle the situation where both HF and VHF band switching is required. Further details are provided on this page. If that doesn't work, and you really have to use the TRN setting, you have two other band-switching options for the KPA500: its own front-panel switches, and RF sensing. 73, Wayne N6KR On Jan 20, 2014, at 5:31 PM, Phil Theis <[email protected]> wrote: > Thanks Jack, then I must be changing my KIO3 Setting back and forth between > TRN and Normal based on HF use or VHF use? right > Phil K3TUF > > On 1/20/2014 8:28 PM, Jack Brindle wrote: >> The KPA only talks on the Auxbus, it does not listen. So yes, the four BAND >> signals are needed. >> >> Jack Brindle, W6FB >> >> Sent from my iPhone >> >>> On Jan 20, 2014, at 5:23 PM, Phil Theis <[email protected]> wrote: >>> >>> In the KPA cable going to the K3 the band data lines are called out, yet >>> there is no discussion about instructing the K3 firmware to set band data. >>> My band data is used for transverters with Config:KIO3 set to TRN. If >>> these lines are not used and band information is derived from AUXBUS, then >>> do we really need the four band lines in the cable going from KPA to K3? >>> thanks, >>> Phil K3TUF >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
