Hello all,
Finally after 8 month I'm building the KPA100 module and hope to install this option next weekend. But when reading the manual on page 21 it is suggested to cut pin 4 of the P4 connector (used for the ribbon cable) as to introduce some kind of a key. Except if you expect to use this pin (8T 8-volt transmit) for any reason. I can't figure out at this stage if I will need this "signal" for any kind of homebrew option. I hate cutting pins and find out next month that I shouldn't have done it. Does anyone know about any kind of modification that might need this 8T line? Thanks in advance. Evert, PA2KW K2 : sn 4836 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
