Dr. Werner Furlan wrote: > I should have posted this before... > I found a related message when searching the archive. The reply was: > > ------------------ > Sounds exactly like the problem I had with 5196. The problem was fixed by > replacing X1 on the Control Board. You will probably find that CtrlBd-U2-1 > goes to about 6 volts when you turn the AGC OFF virtually shitting down the > IF amplifier. I encourage you to communicate with Gary > ([EMAIL PROTECTED]) regarding this problem. Yesterday, someone > reported a > similar problem with a close serial number(s/n5219). > ---------------------- > > My serial # is 5203, so maybe I am also affected by this failure?
Damn, mine too. #5209. Hold PRE/ATT and AGC, it says "OFF", all bars light and the K2 goes deaf. Hold them again, it says "On", the bars come down, and stuff can be heard again. I've not had a chance to measure Ctrl-U2-1. Doing WHAT to the IF amp? Nice typo! :-) -- "Nosey" Nick Waterman, G7RZQ, K2 #5209. use Std::Disclaimer; [EMAIL PROTECTED] Having control over myself is almost as good as having control over others. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
