The real bottom line is to use the indication on the K3 (K3S, KX3 and
KX2) ALC meter.
If you are driving the voice audio up to the 5 to 7 bars level, that is
correct. If it is going higher reduce the MIC gain or switch to the low
mic gain setting.
If it is lower than the 5 to 7 bars, increase the mic gain or switch to
the high mic gain range.
73,
Don W3FPR
On 2/11/2017 10:28 PM, RIchard Williams wrote:
Tom,
I would use whatever setting works the best; if you are receiving good
audio reports, "leave sleeping dogs lie". If your mic gain is set at
something reasonable (mine is "9"), I wouldn't worry about what is
"suggested". Too many variables with your voice characteristics; if
you are calling a "P5" for an ATNO, you might be speaking a bit louder
than working a JA for the 300th time.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
