Congratulations. The K3 is a really nice radio with
extraordinary factory support.
For SSB, I set low cut to .35 KHz and adjust the upper cut
between 1.9 KHz and 2.8 KHz, depending on conditions. Higher
makes for easier copy, but lower will eliminate more noise, and
help with nearby stations. Remember, the crystal filters are to
protect the AtoD converter in the receiver. The DSP has many
useful settings between those of the installed filters.
73 Bill AE6JV
On 6/30/18 at 5:07 PM, [email protected] (Bill) wrote:
I recently purchased a K3 and trying to set up for SSB.I do not do code.
Is there any recommended settings for the shift lo cut and width?
It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed
I have read the manual and it does not really help me.
Thanks
Bill
W3WGG
---------------------------------------------------------------------------
Bill Frantz | Re: Computer reliability, performance, and security:
408-356-8506 | The guy who *is* wearing a parachute is
*not* the
www.pwpconsult.com | first to reach the ground. - Terence Kelly
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
